Dewalt 746 Manual

The Dewalt 746 is a powerful table saw designed for precision and durability. It features a robust motor, a large cutting capacity, and various safety features to ensure user protection. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: High-torque motor, adjustable blade height, and angle, safety guard, and dust collection port.

Feature	Description
High-torque motor	Provides powerful cutting performance
Adjustable blade height	Allows for precise cuts at various thicknesses
Angle adjustment	Enables bevel cuts for versatility
Safety guard	Protects user from blade exposure
Dust collection port	Helps maintain a clean workspace

Installation

Unpack and inspect contents. Place on a stable surface.

1. Assemble the stand: Follow the included instructions to set up the stand securely.
2. Connect the power supply: Ensure the saw is plugged into a grounded outlet.
3. Adjust the blade: Set the blade height and angle according to your cutting needs.

WARNING! Ensure all connections are secure and the workspace is clear of obstacles.

First-Time Setup

Power on the saw; follow the setup instructions in the manual.

1. Check blade alignment: Ensure the blade is parallel to the miter slot.
2. Test the safety features: Verify that the safety guard and riving knife are properly installed.
3. Run a test cut: Make a sample cut to ensure everything is functioning correctly.

CAUTION! Always wear appropriate safety gear when operating the saw.

Specifications

• Motor Power: 15 amps.
• Blade Diameter: 10 inches.
• Cutting Capacity: 24 inches to the right of the blade.
• Weight: 90 lbs.
• Dimensions: 30 x 40 x 36 inches.
• Power Source: 120V AC.
• Operating Temp: 32°F to 104°F.

Controls and Settings

Access controls via the front panel: Power switch, blade height adjustment, and angle adjustment.

Safety Features: Emergency stop button, blade guard, and riving knife.

Connecting Devices

Ensure the saw is off before connecting any devices.

1. Connect dust collection system: Attach the dust port to a compatible vacuum.
2. Use extension cords if necessary: Ensure they are rated for the saw's power requirements.

Tip: Always check connections before starting the saw.

Operating the Saw

Follow safety guidelines when operating the saw.

1. Power on the saw: Ensure the blade is clear before starting.
2. Make your cut: Feed the material steadily through the blade.
3. Power off after use: Always turn off the saw when finished.

WARNING! Keep hands clear of the blade at all times.

Maintenance

Regular maintenance is essential for optimal performance.

1. Clean the saw: Remove sawdust and debris after each use.
2. Check blade condition: Replace dull blades as needed.
3. Inspect safety features: Ensure all safety mechanisms are functioning properly.

Safety Information

Always follow safety precautions when using the saw.

• Wear safety goggles and hearing protection.
• Keep the workspace clean and free of hazards.
• Do not operate the saw under the influence of drugs or alcohol.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Motor won't start	Power supply issue	Check power cord and outlet.
Blade not spinning	Blade jammed	Clear any obstructions and reset the saw.
Inaccurate cuts	Blade misalignment	Adjust blade alignment according to instructions.
Excessive vibration	Loose components	Tighten all screws and bolts.

Service: For further assistance, contact Dewalt customer service.