Dewalt 9.6 Volt NiCad Battery Charger Manual

The Dewalt 9.6 Volt NiCad Battery Charger is designed to charge Dewalt 9.6V NiCad batteries efficiently. This charger features a compact design, LED indicators for charging status, and built-in safety features to prevent overcharging. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Charging Procedure 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Compact design, LED charging indicators, built-in safety features, compatible with Dewalt 9.6V NiCad batteries.

Feature	Description
LED Indicator	Shows charging status (charging, fully charged)
Compact Design	Easy to store and transport
Safety Features	Prevents overcharging and overheating
Compatibility	Designed specifically for Dewalt 9.6V NiCad batteries

Installation

Unpack the charger and inspect for any damage. Place the charger on a stable surface away from moisture.

Connect the charger to a power outlet.
Ensure the battery is properly seated in the charger.
Check that the LED indicator is lit to confirm charging.

WARNING! Do not expose the charger to water or extreme temperatures.

First-Time Setup

Before using the charger for the first time, ensure it is plugged into a suitable power outlet.

Insert the battery into the charger.
Observe the LED indicator for charging status.
Allow the battery to charge fully before first use.

CAUTION! Ensure the charger is unplugged when not in use.

Specifications

Input Voltage: 120V AC.
Output Voltage: 9.6V DC.
Charging Time: Approximately 1-3 hours depending on battery condition.
Compatibility: Dewalt 9.6V NiCad batteries.
Weight: 1.5 lbs.
Dimensions: 6 x 4 x 2 inches.

Controls and Settings

The charger features a simple interface with an LED indicator to show the charging status. No additional controls are required.

Connecting Devices

Ensure the charger is unplugged before connecting or disconnecting the battery.

Align the battery terminals with the charger contacts.
Press down gently until the battery clicks into place.
Plug the charger into a power outlet.

Tip: Always check the LED indicator for charging status.

Charging Procedure

To charge the battery, follow these steps:

Insert the battery into the charger.
Plug the charger into a power outlet.
Monitor the LED indicator for charging status.
Once fully charged, unplug the charger and remove the battery.

WARNING! Do not leave the battery unattended while charging.

Safety Features

The charger includes several safety features to protect against overcharging and overheating.

Care & Cleaning

Unplug the charger before cleaning. Use a dry cloth to wipe the exterior; do not use liquids or aerosols.

CAUTION! Avoid exposing the charger to moisture.

Regulatory Information

This charger complies with applicable safety standards and regulations. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Charger not working	No power supply	Check power outlet and connections.
LED indicator not lit	Battery not seated properly	Remove and reinsert the battery.
Battery not charging	Faulty battery	Replace with a new battery.

Reset: Unplug the charger for 10 seconds and plug it back in.

Service: For assistance, contact Dewalt customer service.