Dewalt Compact Radial Arm Saw 77110 Manual

The Dewalt Compact Radial Arm Saw 77110 is designed for precision cutting and versatility in woodworking projects. This manual provides essential information on safety, features, setup, operation, and maintenance to ensure optimal performance and longevity of your saw.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Maintenance and Care 9. Troubleshooting

Features at a Glance

Key components: 10-inch blade, adjustable arm, built-in laser guide, and dust collection port.

Feature	Description
10-inch Blade	For precise cuts in various materials.
Adjustable Arm	Allows for crosscutting and ripping.
Laser Guide	Helps ensure accurate cuts.
Dust Collection Port	Minimizes debris for a cleaner workspace.
Safety Switch	Prevents accidental start-up.

Installation

Unpack and inspect contents. Place the saw on a stable workbench.

Ensure the work area is clean and well-lit.
Secure the saw to the workbench using bolts.
Connect the dust collection system if available.
Plug into a grounded outlet.

WARNING! Ensure all safety guards are in place before operating.

First-Time Setup

Power on the saw and adjust the blade height and angle as needed.

Set the blade to the desired height for your material.
Adjust the arm for the required cutting angle.
Test the saw with scrap material before actual use.

CAUTION! Always wear safety goggles and hearing protection.

Specifications

Blade Size: 10 inches.
Motor Power: 15 amps.
Cutting Capacity: 2x4 at 90 degrees.
Weight: 50 lbs.
Dimensions: 30 x 20 x 15 inches.
Voltage: 120V AC.

Controls and Settings

Access the main controls on the front panel: power switch, height adjustment, and angle adjustment.

Safety Features: Emergency stop button, blade guard, and anti-kickback pawls.

Connecting Devices

Ensure the saw is unplugged before connecting any devices.

Connect the dust collection hose to the port.
Ensure all cables are secured and away from the cutting area.

Tip: Use a dedicated circuit for optimal performance.

Operating the Saw

Follow these steps for safe operation:

Power on the saw and allow it to reach full speed.
Position the material against the fence and secure it.
Make the cut using a steady motion.
Power off the saw after use and unplug it.

WARNING! Never reach over the blade while it is in motion.

Maintenance and Care

Regular maintenance is essential for optimal performance.

Keep the blade clean and sharp.
Inspect the power cord for damage.
Lubricate moving parts as per the manufacturer's guidelines.

CAUTION! Always unplug the saw before performing maintenance.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Power supply issue	Check power cord and outlet.
Blade not spinning	Motor failure	Contact service center for repair.
Inaccurate cuts	Misalignment	Adjust the blade and fence alignment.
Excessive vibration	Loose components	Check and tighten all screws and bolts.

Service: For assistance, contact Dewalt customer service.