Dewalt D55146 Manual PDF

The Dewalt D55146 is a portable air compressor designed for heavy-duty applications. It features a 4.5-gallon tank, a powerful 1.6 HP motor, and a maximum pressure of 200 PSI, making it ideal for powering pneumatic tools and inflating tires. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 4.5-gallon tank, 1.6 HP motor, maximum pressure of 200 PSI, quick recovery time, and lightweight design for portability.

Feature	Description
4.5-gallon tank	Provides ample air supply for various applications
1.6 HP motor	Delivers powerful performance for demanding tasks
200 PSI maximum pressure	Suitable for a wide range of pneumatic tools
Quick recovery time	Reduces downtime between tasks
Lightweight design	Easy to transport and maneuver

Installation

Unpack and inspect the compressor. Place it on a stable surface away from moisture.

Connect the air hose: Ensure the compressor is off before connecting.
Plug into a power source: Use a grounded outlet to prevent electrical hazards.
Check for leaks: Turn on the compressor and inspect all connections.

WARNING! Ensure the compressor is properly grounded to avoid electrical shock.

First-Time Setup

Power on the compressor; set the desired pressure using the regulator.

Adjust pressure: Use the pressure gauge to set the desired PSI.
Test operation: Run the compressor briefly to ensure functionality.

CAUTION! Do not exceed the maximum pressure rating.

Specifications

Tank Size: 4.5 gallons.
Motor Power: 1.6 HP.
Maximum Pressure: 200 PSI.
Weight: 40 lbs.
Dimensions: 18 x 18 x 18 inches.
Power Source: 120V AC.
Operating Temperature: 32°F to 104°F.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel.

Pressure Regulator: Adjusts the output pressure for connected tools.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

Connect pneumatic tools using the air hose and quick couplers.

Ensure the compressor is off before connecting tools.
Match the tool's air inlet to the hose fitting.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

Follow these steps to operate the compressor safely and effectively.

Turn on the compressor using the on/off switch.
Adjust the pressure to match the requirements of your tool.
Monitor the pressure gauge during operation.
Turn off the compressor when finished.

WARNING! Do not operate the compressor in wet conditions.

Maintenance

Regular maintenance is essential for optimal performance.

Check oil levels: Ensure the motor oil is at the recommended level.
Clean air filter: Replace or clean the air filter regularly.
Inspect hoses: Look for wear and replace if necessary.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor.

Keep the compressor away from flammable materials.
Do not exceed the maximum pressure rating.
Use personal protective equipment when operating pneumatic tools.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check power cord and outlet.
No pressure	Leak in hose	Inspect and replace damaged hoses.
Excessive noise	Loose components	Tighten all screws and fittings.
Pressure gauge not working	Faulty gauge	Replace the pressure gauge.

Reset: Unplug and plug back in to reset the compressor.

Service: Contact Dewalt customer service for assistance.