Dewalt DC9319 Manual

The Dewalt DC9319 is a high-performance battery charger designed for use with Dewalt 18V and 20V MAX lithium-ion batteries. This charger features a fast charging capability, allowing users to quickly recharge their batteries and minimize downtime. It is equipped with an LED indicator that displays the charging status, ensuring users are informed about the battery's charge level. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating Instructions 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Fast charging capability, LED indicator, compatibility with Dewalt 18V and 20V MAX batteries.

Feature	Description
Fast Charging	Reduces downtime by quickly charging batteries.
LED Indicator	Displays charging status and battery health.
Compatibility	Works with Dewalt 18V and 20V MAX lithium-ion batteries.
Compact Design	Easy to store and transport.
Durable Construction	Built to withstand tough job site conditions.

Installation

Unpack the charger and inspect for any damage. Place it on a stable surface away from moisture.

Connect the charger to a power outlet using the provided power cord.
Ensure the charger is in a well-ventilated area.
Check that the LED indicator is functioning properly.

WARNING! Do not expose the charger to rain or moisture to avoid electrical hazards.

First-Time Setup

Before using the charger for the first time, ensure it is properly connected to a power source.

Insert the battery into the charger until it clicks into place.
Observe the LED indicator to confirm charging has started.
Allow the battery to charge fully before first use for optimal performance.

CAUTION! Do not attempt to charge non-Dewalt batteries as it may damage the charger.

Specifications

Input Voltage: 120V AC.
Output Voltage: 18V and 20V MAX.
Charging Time: Approximately 1 hour for a standard battery.
Weight: 2.5 lbs.
Dimensions: 10 x 8 x 4 inches.
LED Indicator: Yes, for charging status.
Compatibility: Dewalt 18V and 20V MAX lithium-ion batteries.

Controls and Settings

The charger features a simple interface with an LED indicator that shows the charging status. There are no additional controls required for operation.

Connecting Devices

To charge a battery, simply insert it into the charger until it clicks into place. Ensure the charger is plugged into a power outlet.

Turn off the charger before connecting or disconnecting batteries.
Ensure the battery is aligned correctly with the charger.

Tip: Always check the LED indicator for charging status.

Operating Instructions

To operate the charger, simply insert the battery and plug it into a power source. The LED indicator will show the charging status.

Insert the battery into the charger.
Plug the charger into an electrical outlet.
Monitor the LED indicator for charging progress.

WARNING! Do not leave the charger unattended while in use.

Maintenance

Keep the charger clean and free from dust. Unplug when not in use and store in a dry place.

CAUTION! Do not attempt to open or repair the charger yourself.

Regulatory Information

This charger complies with all applicable safety standards and regulations. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
LED indicator not lit	No power supply	Check power connection and outlet.
Battery not charging	Incompatible battery	Ensure battery is Dewalt compatible.
Overheating	Blocked ventilation	Ensure charger is in a well-ventilated area.
Charging time too long	Old battery	Consider replacing the battery.

Reset: Unplug the charger for 10 seconds and plug it back in.

Service: For assistance, contact Dewalt customer service.