Dewalt DC9320 Manual

The Dewalt DC9320 is a high-performance battery charger designed for use with Dewalt 18V NiCad and Lithium-Ion batteries. It features a fast charging capability, allowing you to quickly recharge your batteries so you can get back to work. The charger is equipped with an LED indicator that shows the charging status, and it is designed to be compact and portable for easy handling. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Fast charging capability, LED status indicator, compact design, compatible with Dewalt 18V batteries.

Feature	Description
Fast Charging	Charges batteries quickly to minimize downtime
LED Indicator	Shows charging status (charging, charged, or fault)
Compact Design	Easy to transport and store
Compatibility	Works with Dewalt 18V NiCad and Lithium-Ion batteries

Installation

Unpack the charger and inspect for any damage. Place it on a stable surface near a power outlet.

1. Connect the charger to a power source.
2. Ensure the area is well-ventilated during charging.
3. Keep the charger away from moisture and extreme temperatures.

WARNING! Do not use the charger if it is damaged; contact customer service for assistance.

First-Time Setup

Plug the charger into a power outlet and ensure it is functioning correctly.

1. Insert the battery into the charger.
2. Check the LED indicator for charging status.
3. Remove the battery once fully charged.

CAUTION! Do not leave the battery in the charger for extended periods after it is fully charged.

Specifications

• Input Voltage: 120V AC.
• Output Voltage: 18V DC.
• Charging Time: Approximately 1 hour for most batteries.
• Weight: 2.5 lbs.
• Dimensions: 8 x 6 x 4 inches.
• Compatibility: Dewalt 18V NiCad and Lithium-Ion batteries.

Controls and Settings

The charger features a simple interface with an LED indicator for easy monitoring of the charging process.

LED Status: Indicates charging status (charging, charged, or fault).

Connecting Devices

To charge a battery, simply insert it into the charger until it clicks into place.

1. Ensure the charger is unplugged before inserting or removing batteries.
2. Align the battery with the charging contacts.
3. Plug the charger into a power outlet to begin charging.

Tip: Always check the LED indicator for proper charging status.

Operating Instructions

To operate the charger, follow these steps:

1. Plug the charger into an electrical outlet.
2. Insert the battery into the charger.
3. Monitor the LED indicator for charging status.
4. Once charged, remove the battery and unplug the charger.

WARNING! Do not attempt to charge non-Dewalt batteries.

Safety Features

The charger is equipped with several safety features to protect against overheating and overcharging.

Care & Cleaning

Unplug the charger before cleaning. Use a dry cloth to wipe the exterior; do not use liquids.

CAUTION! Avoid exposing the charger to moisture or extreme temperatures.

Regulatory Information

This charger complies with all applicable safety standards and regulations. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Charger not working	No power	Check power outlet and connections.
LED indicator not lit	Battery not inserted properly	Remove and reinsert the battery.
Battery not charging	Faulty battery	Test with another battery.
Overheating	Blocked ventilation	Ensure charger is in a well-ventilated area.

Reset: Unplug the charger for 10 seconds and plug it back in.

Service: 1-800-433-9258; www.dewalt.com