Dewalt DC970 Drill Manual

The Dewalt DC970 is a powerful 18V cordless drill that combines versatility and performance. It features a compact design, lightweight construction, and a high-performance motor that delivers up to 380 unit watts out for maximum power. The drill is equipped with a two-speed transmission (0-450 RPM and 0-1500 RPM) for optimal speed control, making it suitable for a variety of applications. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 18V battery, two-speed transmission, keyless chuck, ergonomic handle, and LED work light.

Installation

Unpack the drill and inspect all components. Ensure the battery is charged before use.

1. Insert the battery pack into the drill until it clicks into place.
2. Choose the appropriate drill bit for your task and insert it into the keyless chuck.
3. Adjust the torque setting according to the material being drilled.
4. Ensure the drill is set to the correct speed for your application.

WARNING! Always wear safety goggles when operating the drill.

First-Time Setup

Power on the drill by inserting the battery pack and ensuring it is securely locked in place.

1. Familiarize yourself with the controls and settings on the drill.
2. Practice using the drill on scrap material to get comfortable with its operation.
3. Adjust the settings as needed for your specific drilling tasks.

CAUTION! Ensure the drill is off when changing bits or making adjustments.

Specifications

• Voltage: 18V.
• Max Torque: 380 in-lbs.
• Speed: 0-450 RPM (low), 0-1500 RPM (high).
• Chuck Size: 1/2 inch keyless chuck.
• Weight: 5.2 lbs.
• Battery Type: Lithium-ion.
• Charging Time: 30-60 minutes.

Controls and Settings

Access the speed settings via the gear switch located on the top of the drill. The torque adjustment ring allows you to set the desired torque for different materials.

LED Indicator: Shows battery status and charging progress.

Use the trigger to control the speed and direction of the drill.

Connecting Accessories

Ensure the drill is powered off before connecting any accessories.

1. Choose the appropriate drill bit or accessory for your task.
2. Insert the accessory into the keyless chuck and tighten securely.
3. Adjust the settings as needed for the specific accessory being used.

Tip: Always use the correct accessory for the material you are working with.

Using the Drill

To use the drill, hold it firmly with both hands and position it at the desired angle.

1. Press the trigger to start drilling.
2. Apply steady pressure without forcing the drill.
3. Release the trigger to stop drilling.
4. For driving screws, switch to the appropriate torque setting.

WARNING! Keep hands clear of the drill bit while in operation.

Maintenance

Regular maintenance is essential for optimal performance.

• Clean the drill after each use to remove dust and debris.
• Check the battery for any signs of damage or wear.
• Store the drill in a dry place away from extreme temperatures.

Safety Information

Always follow safety guidelines when using the drill.

• Wear appropriate personal protective equipment (PPE).
• Keep the work area clean and well-lit.
• Do not operate the drill in wet or damp conditions.

Troubleshooting

Reset: If issues persist, consult the user manual or contact customer support.

Service: For assistance, contact Dewalt customer service at 1-800-433-9258.