Dewalt DC970K-2 18-Volt Drill/Driver Kit Manual

The Dewalt DC970K-2 is an 18-volt cordless drill/driver kit designed for both professional and DIY use. It features a high-performance motor that delivers 380 unit watts out (UWO) of power, making it suitable for a variety of drilling and fastening applications. The kit includes two 18-volt NiCad batteries, a charger, and a carrying case. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Accessories 7. Operating the Drill/Driver 8. Maintenance and Care 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 18-volt cordless drill, two NiCad batteries, charger, carrying case.

Feature	Description
High-performance motor	Delivers 380 UWO for efficient drilling and fastening
Two-speed transmission	0-450 RPM and 0-1500 RPM for versatility
1/2-inch single sleeve chuck	Allows for easy bit changes
Compact design	Lightweight and easy to handle
Built-in LED light	Illuminates work area for better visibility

Installation

Unpack the drill/driver kit and inspect contents. Ensure all components are included.

Charge the batteries fully before first use.
Attach the battery to the drill until it clicks into place.
Select the desired speed setting based on the application.
Insert the drill bit into the chuck and tighten securely.

WARNING! Always wear safety goggles when operating the drill.

First-Time Setup

Power on the drill; ensure the battery is charged.

Choose the appropriate drill bit for your project.
Adjust the torque settings as needed for different materials.
Practice drilling on scrap material to get comfortable with controls.

CAUTION! Ensure the work surface is stable and secure.

Specifications

Voltage: 18 volts.
Battery Type: NiCad.
Chuck Size: 1/2 inch.
Speed Settings: Two-speed (0-450 RPM, 0-1500 RPM).
Weight: 5.2 lbs.
Dimensions: 9.5 x 10.5 x 3.5 inches.
LED Light: Yes.

Controls and Settings

Access speed settings via the gear switch located on the top of the drill. The torque adjustment ring allows for precise control based on the material being drilled.

Battery Indicator: Check the battery level using the indicator light on the drill.

Connecting Accessories

Ensure the drill is powered off before changing bits or accessories.

Press the chuck release button to open the chuck.
Insert the drill bit and tighten the chuck securely.
Select the appropriate speed and torque settings for the accessory.

Tip: Always use the correct bit for the material to avoid damage.

Operating the Drill/Driver

To operate the drill, press the trigger to start. Release to stop. Use the forward/reverse switch to change the direction of rotation.

For drilling, apply steady pressure and let the drill do the work.
For driving screws, adjust the torque setting to prevent stripping.

WARNING! Keep hands clear of the drill bit while in operation.

Maintenance and Care

Regularly clean the drill and check for wear on the battery and bits.

CAUTION! Unplug and remove the battery before cleaning.

Safety Information

Always follow safety guidelines when operating power tools. Wear appropriate personal protective equipment.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Drill won't start	Battery not charged	Charge the battery fully before use.
Bit slipping	Chuck not tightened	Tighten the chuck securely around the bit.
Overheating	Continuous use	Allow the drill to cool down before resuming use.
Battery not holding charge	Old battery	Replace with a new battery.

Service: For assistance, contact Dewalt customer service at 1-800-433-9258.