Dewalt DCB100 Instruction Manual

The Dewalt DCB100 is a compact and efficient battery charger designed for Dewalt 20V MAX lithium-ion batteries. It features a lightweight design, fast charging capabilities, and an LED indicator to show the charging status. This manual provides essential information on safety, features, installation, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating Instructions 8. Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key features include: fast charging, compatibility with Dewalt 20V MAX batteries, compact design, and LED charging status indicator.

Feature	Description
Fast Charging	Charges batteries quickly to minimize downtime.
LED Indicator	Shows charging status and battery health.
Compact Design	Easy to transport and store.
Compatibility	Works with all Dewalt 20V MAX lithium-ion batteries.

Installation

Unpack the charger and inspect for any damage. Place the charger on a stable surface away from moisture.

Plug the charger into a standard electrical outlet.
Ensure the outlet is functioning properly.
Keep the charger away from direct sunlight and heat sources.

WARNING! Do not expose the charger to water or extreme temperatures.

First-Time Setup

To set up your charger for the first time, follow these steps:

Connect the charger to a power source.
Insert the battery into the charger.
Observe the LED indicator for charging status.

CAUTION! Ensure the battery is compatible with the charger.

Specifications

Input Voltage: 120V AC.
Output Voltage: 20V DC.
Charging Time: Approximately 1 hour for a 2.0Ah battery.
Weight: 1.5 lbs.
Dimensions: 8 x 5 x 3 inches.
Compatibility: Dewalt 20V MAX lithium-ion batteries.

Controls and Settings

The charger features a simple interface with an LED indicator to show charging status. No additional controls are required.

Connecting Devices

To connect the charger to a battery:

Align the battery with the charger slot.
Press down until the battery clicks into place.
Ensure the LED indicator lights up to confirm connection.

Tip: Always check for compatibility before connecting.

Operating Instructions

To operate the charger:

Insert the battery and plug in the charger.
Monitor the LED indicator for charging status.
Once fully charged, remove the battery from the charger.

WARNING! Do not leave the battery on the charger for extended periods after charging is complete.

Maintenance

Keep the charger clean and free from debris. Unplug when not in use and store in a dry place.

CAUTION! Do not attempt to open or repair the charger yourself.

Regulatory Information

This device complies with FCC Part 15. For more information, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Charger does not work	No power supply	Check outlet and power cord.
LED indicator not lit	Battery not connected	Ensure battery is properly seated.
Battery not charging	Faulty battery	Test with another battery.
Overheating	Blocked ventilation	Ensure charger is in a well-ventilated area.

Reset: Unplug the charger for 10 seconds and plug it back in.

Service: For assistance, contact Dewalt customer service.