Dewalt DE9118 Charger Manual

The Dewalt DE9118 is a high-performance battery charger designed for use with Dewalt 18V NiCd and NiMH batteries. This charger features a compact design, LED indicator lights for charging status, and a built-in cooling system to ensure optimal battery performance. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Charging Batteries 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Compact design, LED indicators, built-in cooling system, compatible with Dewalt 18V batteries.

Feature	Description
LED Indicator Lights	Shows charging status (charging, charged, fault)
Cooling System	Prevents overheating during charging
Compact Design	Easy to store and transport
Compatibility	Works with Dewalt 18V NiCd and NiMH batteries

Installation

Unpack and inspect contents. Place charger on a stable surface away from moisture.

Connect to power source: Plug the charger into a standard AC outlet.
Ensure proper ventilation: Keep the charger in a well-ventilated area.

WARNING! Do not expose charger to rain or moisture. Ensure all connections are secure.

First-Time Setup

Power on charger; ensure it is connected to a power source.

Insert battery: Align battery with charger contacts and push down until secure.
Check LED indicators: Ensure the charging light is illuminated.

CAUTION! Ensure charger is unplugged before inserting or removing batteries.

Specifications

Input Voltage: 120V AC.
Output Voltage: 18V DC.
Charging Time: Approximately 1 hour for a standard battery.
Compatibility: Dewalt 18V NiCd and NiMH batteries.
Weight: 1.5 lbs.
Dimensions: 8 x 5 x 3 inches.

Controls and Settings

Access charging status via LED indicators. No additional settings required for operation.

LED Indicators: Charging (blinking), Charged (solid), Fault (red).

Connecting Devices

Charger: Connect to a standard AC outlet. Batteries: Align and insert into charger.

Ensure charger is unplugged before connecting batteries.
Match battery contacts to charger contacts.

Tip: Always check for proper alignment before inserting batteries.

Charging Batteries

Supports Dewalt 18V NiCd and NiMH batteries.

Insert battery: Press down until secure.
Monitor charging: Check LED indicators for status.
Remove battery: Unplug charger and press battery release button.

WARNING! Do not attempt to charge non-compatible batteries.

Safety Features

Overcharge protection, short circuit protection, and thermal protection to ensure safe operation.

Care & Cleaning

Unplug before cleaning. Use a dry cloth to clean the exterior; do not use liquids.

CAUTION! Avoid using abrasive cleaners or solvents.

Regulatory Information

Complies with FCC Part 15 regulations for digital devices. For support, visit www.dewalt.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Charger does not power on	Power source issue	Check outlet and power cord connections.
Battery not charging	Improper connection	Ensure battery is properly seated in charger.
LED indicator not lit	Faulty charger	Contact customer service for support.

Reset: Unplug charger for 10 seconds, then reconnect.

Service: 1-800-433-9258; www.dewalt.com