Dewalt DW705 Parts Manual

The Dewalt DW705 is a powerful miter saw designed for precision cutting in various materials. This manual provides detailed information on parts, assembly, maintenance, and troubleshooting to ensure optimal performance and longevity of your tool. Below are key sections for parts identification, assembly instructions, maintenance tips, and troubleshooting.

1. Parts Identification 2. Assembly Instructions 3. Maintenance Tips 4. Specifications 5. Troubleshooting

Parts Identification

Familiarize yourself with the key components of the Dewalt DW705 miter saw.

Part	Description
Blade Guard	Protects the user from the blade during operation
Table	Provides a stable surface for cutting materials
Handle	Used to operate the saw
Motor	Drives the blade for cutting
Base	Supports the entire saw assembly
Bevel Lock	Locks the saw at desired bevel angles
Power Switch	Turns the saw on and off

Assembly Instructions

Follow these steps to properly assemble your Dewalt DW705 miter saw.

Unpack all components and ensure all parts are included.
Attach the base to the table using the provided screws.
Install the blade guard by aligning it with the mounting holes.
Secure the motor to the base with the appropriate fasteners.
Connect the power switch to the motor according to the wiring diagram.

WARNING! Ensure all parts are securely fastened before operating the saw.

Maintenance Tips

Regular maintenance will prolong the life of your miter saw.

Keep the saw clean and free of debris.
Check and replace the blade regularly for optimal performance.
Lubricate moving parts as specified in the manual.
Inspect electrical components for wear and damage.

CAUTION! Always unplug the saw before performing maintenance.

Specifications

Model: Dewalt DW705
Power: 15 Amp motor
Blade Size: 12 inches
Bevel Capacity: 0-45 degrees
Weight: 50 lbs
Cutting Capacity: 2x8 at 90 degrees
Voltage: 120V AC

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw won't start	Power supply issue	Check power cord and outlet
Blade not spinning	Motor failure	Inspect motor and replace if necessary
Inaccurate cuts	Misalignment	Adjust the blade and table alignment
Excessive vibration	Loose parts	Tighten all screws and bolts

Reset: Refer to the manual for reset instructions if available.

Service: Contact Dewalt customer service for further assistance.