Dewalt DW708 User Manual

The Dewalt DW708 is a powerful 12-inch double bevel sliding compound miter saw designed for precision and versatility in cutting various materials. It features a robust motor, adjustable miter and bevel settings, and a laser guide for enhanced accuracy. This manual provides essential information on safety, features, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Saw 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 12-inch blade, double bevel capability, sliding feature, laser guide, adjustable miter and bevel angles.

Feature	Description
12-inch Blade	For cutting through a variety of materials with precision.
Double Bevel	Allows for bevel cuts in both directions without flipping the workpiece.
Sliding Feature	Increases cutting capacity for wider materials.
Laser Guide	Helps ensure accurate cuts by projecting a line on the workpiece.
Adjustable Miter Angles	Enables precise angle cuts from 0 to 50 degrees.
Dust Collection	Integrated system to minimize dust and debris during operation.

Installation

Ensure a stable and secure work surface. Follow these steps for installation:

Unpack the saw and inspect for any damage.
Securely mount the saw to a workbench or stand.
Connect the dust collection system if applicable.
Ensure all safety guards are in place before use.

WARNING! Always wear appropriate safety gear when operating the saw.

First-Time Setup

Before using the saw for the first time, follow these setup instructions:

Adjust the miter and bevel settings to the desired angles.
Install the blade securely, ensuring it is properly tightened.
Check the laser alignment and adjust if necessary.
Test the saw with a scrap piece of material to ensure proper operation.

CAUTION! Ensure the saw is unplugged when making adjustments.

Specifications

Blade Size: 12 inches.
Motor Power: 15 amps.
Bevel Capacity: 0 to 48 degrees left and right.
Miter Capacity: 0 to 50 degrees left and right.
Weight: Approximately 50 lbs.
Dust Port Diameter: 2-1/2 inches.
Laser Guide: Yes, included.

Controls and Settings

Familiarize yourself with the controls of the saw:

Power switch, miter adjustment knob, bevel adjustment lever, and laser activation switch.

Connecting Devices

Ensure proper connections for dust collection and power supply:

Connect the dust collection hose to the port on the saw.
Plug the saw into a grounded outlet.

Tip: Use a dedicated circuit to prevent tripping breakers.

Operating the Saw

Follow these steps to operate the saw safely:

Ensure the workpiece is secured before cutting.
Adjust the blade height as needed.
Turn on the saw and allow it to reach full speed.
Make the cut, keeping hands clear of the blade.
Turn off the saw and wait for the blade to stop before removing the workpiece.

WARNING! Never reach over the blade while it is in motion.

Maintenance

Regular maintenance is essential for optimal performance:

Keep the saw clean and free of debris.
Inspect and replace the blade as needed.
Check the laser alignment periodically.
Lubricate moving parts as per the manufacturer's recommendations.

Safety Information

Always prioritize safety when using the saw:

Wear safety glasses and hearing protection.
Keep hands away from the blade.
Do not operate the saw under the influence of drugs or alcohol.
Read and understand the manual before use.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Blade not spinning	Power issue	Check power supply and connections.
Laser not working	Battery issue	Replace the battery in the laser unit.
Uneven cuts	Blade alignment	Check and adjust blade alignment.
Excessive vibration	Loose components	Inspect and tighten all screws and bolts.

Service: For further assistance, contact Dewalt customer service.