Dewalt DW715 Parts Manual

The Dewalt DW715 is a powerful miter saw designed for precision and durability. This manual provides detailed information about the parts and components of the DW715, ensuring you have the necessary information for maintenance, repairs, and replacements. Below are key sections for parts identification, assembly, maintenance, and troubleshooting.

1. Parts Identification 2. Assembly Instructions 3. Maintenance Guidelines 4. Specifications 5. Troubleshooting

Parts Identification

Understanding the parts of your Dewalt DW715 is crucial for effective operation and maintenance. Below is a list of key components:

Part	Description
Blade Guard	Protects the user from the blade during operation
Table	Provides a stable surface for cutting materials
Motor	Drives the blade for cutting
Handle	Used to operate the saw
Base	Supports the entire saw assembly
Bevel Lock	Locks the saw at the desired bevel angle
Fence	Guides the material for accurate cuts

Assembly Instructions

Follow these steps to assemble your Dewalt DW715:

Unpack all components and check against the parts list.
Attach the base to the table using the provided screws.
Install the motor assembly onto the table.
Secure the blade guard in place.
Connect the power cord to the motor.

WARNING! Ensure all parts are securely fastened before operation.

Maintenance Guidelines

Regular maintenance is essential for optimal performance:

Clean the saw after each use to remove dust and debris.
Inspect the blade for wear and replace if necessary.
Lubricate moving parts as per the manufacturer's recommendations.
Check electrical connections for wear or damage.

CAUTION! Always unplug the saw before performing maintenance.

Specifications

Model: Dewalt DW715
Power: 15 Amp motor
Blade Size: 12 inches
Bevel Capacity: 0-48 degrees
Weight: 42 lbs
Cutting Capacity: 2x8 at 90 degrees
Voltage: 120V

Troubleshooting

Symptom	Possible Cause	Corrective Action
Blade does not spin	Power supply issue	Check power cord and outlet
Inaccurate cuts	Misalignment	Adjust the fence and blade alignment
Excessive vibration	Loose parts	Check and tighten all screws and bolts
Overheating	Blocked vents	Clean vents and allow cooling

Reset: Disconnect power and reconnect after a few minutes if issues persist.

Service: For further assistance, contact Dewalt customer service.