Dewalt DW717 Manual

The Dewalt DW717 is a 10-inch double bevel sliding compound miter saw designed for precision and versatility. It features a powerful motor, adjustable bevel settings, and a large cutting capacity, making it ideal for both professional and DIY projects. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 10-inch blade, double bevel capability, sliding feature, adjustable miter angles, and laser guide for precision cutting.

Feature	Description
10-inch Blade	For cutting a variety of materials with precision.
Double Bevel	Allows for bevel cuts in both directions.
Sliding Feature	Increases cutting capacity for wider materials.
Laser Guide	Helps ensure accurate cuts.
Adjustable Miter Angles	For precise angle cuts up to 60 degrees.

Installation

Unpack and inspect contents. Place on a stable work surface.

1. Attach the saw to a workbench or stand for stability.
2. Ensure the power cord is properly connected to a power source.
3. Check that the blade is securely installed and aligned.

WARNING! Ensure all safety guards are in place before operating the saw.

First-Time Setup

Power on the saw; follow initial setup instructions.

1. Adjust the miter angle to 0 degrees for standard cuts.
2. Set the bevel angle to your desired setting.
3. Test the laser guide alignment before making cuts.

CAUTION! Always wear safety goggles when operating the saw.

Specifications

• Blade Size: 10 inches.
• Motor Power: 15 amps.
• Bevel Capacity: 0 to 48 degrees left and right.
• Miter Capacity: 0 to 60 degrees right and 0 to 50 degrees left.
• Weight: 50 lbs.
• Cutting Capacity: 2x8 at 90 degrees, 2x6 at 45 degrees.
• Laser Guide: Yes.

Controls and Settings

Access the miter and bevel adjustments easily located on the saw.

Controls: Miter lock, bevel adjustment lever, and power switch.

Ensure all settings are locked before making cuts.

Connecting Devices

Ensure the saw is connected to a power source before use.

1. Use a heavy-duty extension cord if needed.
2. Ensure the work area is clear of obstructions.

Tip: Always check the power source before starting the saw.

Operating the Saw

Follow these steps for safe operation:

1. Adjust the miter and bevel settings as needed.
2. Place the material securely against the fence.
3. Power on the saw and make the cut.
4. Turn off the saw and wait for the blade to stop before removing the material.

WARNING! Keep hands away from the blade while cutting.

Maintenance

Regular maintenance is essential for optimal performance.

1. Keep the saw clean and free of debris.
2. Check blade sharpness and replace if necessary.
3. Inspect power cord for damage.

CAUTION! Unplug the saw before performing any maintenance.

Safety Information

Always follow safety guidelines when operating the saw.

• Wear appropriate personal protective equipment (PPE).
• Keep the work area well-lit and organized.
• Do not operate the saw under the influence of drugs or alcohol.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw does not start	Power source issue	Check power cord and outlet.
Blade not spinning	Motor issue	Inspect motor and connections.
Inaccurate cuts	Misalignment	Check and adjust miter and bevel settings.
Excessive vibration	Blade issue	Check blade for damage; replace if necessary.

Reset: Ensure all settings are correct before use.

Service: Contact Dewalt customer service for assistance.