Dewalt DW733-XE Manual

The Dewalt DW733-XE is a powerful and versatile thickness planer designed for professional woodworkers and DIY enthusiasts. It features a 15-amp motor that delivers a smooth and consistent cut, allowing you to plane boards up to 13 inches wide and 6 inches thick. The DW733-XE is equipped with a three-blade cutter head that provides a superior finish and reduces snipe. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Planer 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 15-amp motor, three-blade cutter head, adjustable depth control, and onboard storage for accessories.

Feature	Description
15-amp motor	Powerful motor for smooth and consistent cuts
Three-blade cutter head	Provides a superior finish and reduces snipe
Adjustable depth control	Allows for precise thickness adjustments
Onboard storage	Convenient storage for accessories and tools
Dust port	Connects to vacuum for efficient dust collection

Installation

Unpack and inspect contents. Place the planer on a stable surface.

Ensure the area is clean and free of debris.
Connect the dust port to a vacuum for optimal dust collection.
Plug the planer into a suitable power outlet.

WARNING! Ensure all connections are secure and the planer is stable before use.

First-Time Setup

Power on the planer and adjust the depth settings as needed.

Set the desired thickness using the depth adjustment knob.
Ensure the blades are sharp and properly installed.
Run a test piece to ensure settings are correct.

CAUTION! Always wear appropriate safety gear when operating the planer.

Specifications

Motor: 15-amp, 120V.
Planing Width: 13 inches.
Planing Depth: Up to 6 inches.
Cutter Head: Three-blade design.
Weight: 80 lbs.
Dust Port Diameter: 2.5 inches.
Power Source: Corded electric.

Controls and Settings

Access the depth adjustment knob and power switch located on the front panel.

Features: Depth adjustment, power switch, and dust port connection.

Connecting Devices

Ensure the planer is connected to a suitable vacuum for dust collection.

Turn off the planer before connecting or disconnecting the dust port.
Match the dust port to the vacuum hose for a secure fit.

Tip: Always check for clogs in the dust collection system.

Operating the Planer

Follow these steps to operate the planer safely and effectively.

Power on the planer and set the desired thickness.
Feed the wood slowly and steadily into the planer.
Monitor the output for consistent thickness.

WARNING! Do not force the wood; let the planer do the work.

Maintenance

Regular maintenance is essential for optimal performance.

Clean the blades and dust port after each use.
Check for wear and replace blades as necessary.
Store the planer in a dry place to prevent rust.

Safety Information

Always follow safety guidelines when operating the planer.

Wear safety goggles and ear protection.
Keep hands away from moving parts.
Do not operate in wet conditions.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Planer won't start	No power	Check power source and connections.
Uneven cuts	Blades dull	Sharpen or replace blades.
Excessive noise	Loose parts	Tighten all screws and bolts.
Dust collection ineffective	Clogged dust port	Clear any blockages.

Service: Contact Dewalt customer service for assistance.