Dewalt DW960 Manual

The Dewalt DW960 is a powerful cordless drill designed for both professional and DIY use. It features a high-performance motor, a 1/2-inch keyless chuck, and a two-speed transmission for versatility in various applications. With its ergonomic design and lightweight construction, the DW960 provides comfort and control during extended use. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating Instructions 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: High-performance motor, 1/2-inch keyless chuck, two-speed transmission, ergonomic handle, LED work light.

Feature	Description
High-performance motor	Delivers maximum power for tough applications
1/2-inch keyless chuck	Allows for quick and easy bit changes
Two-speed transmission	Provides versatility for various drilling and driving tasks
Ergonomic handle	Designed for comfort and reduced fatigue
LED work light	Illuminates dark work areas

Installation

Unpack and inspect the drill and accessories. Ensure all components are included.

Charge the battery: Insert the battery into the charger until fully charged.
Attach the battery: Align the battery with the base of the drill and push until it clicks.
Select the drill setting: Choose between drill or driver mode using the mode selector.

WARNING! Always wear safety goggles when operating the drill.

First-Time Setup

Power on the drill; ensure the battery is charged and properly attached.

Test the drill: Press the trigger to ensure it operates correctly.
Adjust the torque: Use the torque adjustment collar to set the desired torque level.
Practice drilling: Use a scrap piece of wood to familiarize yourself with the drill's operation.

CAUTION! Keep hands away from the drill bit while in operation.

Specifications

Voltage: 18V.
Chuck Size: 1/2 inch.
Speed: 0-450/0-1500 RPM.
Torque: 400 in-lbs.
Weight: 4.5 lbs.
Battery Type: Lithium-ion.
Charging Time: 1 hour.

Controls and Settings

Access drill settings via the mode selector and torque adjustment collar. The trigger controls the speed and operation of the drill.

LED Indicator: Indicates battery status and charging.

Connecting Devices

Ensure the drill is powered off before connecting any accessories.

Insert drill bit: Open the chuck, insert the bit, and tighten securely.
Attach accessories: Use the appropriate attachment for the task at hand.

Tip: Always use the correct bit for the material being drilled.

Operating Instructions

Follow these steps to operate the drill effectively:

Choose the correct speed setting based on the material.
Apply steady pressure while drilling.
Release the trigger to stop the drill.

WARNING! Do not overload the drill; let it cool down if it overheats.

Maintenance

Regular maintenance ensures optimal performance:

Clean the drill after each use.
Check and replace worn bits.
Store in a dry place to prevent corrosion.

CAUTION! Unplug the charger before cleaning.

Safety Information

Always follow safety guidelines when operating the drill:

Wear appropriate personal protective equipment.
Keep work area clean and well-lit.
Do not operate in wet conditions.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Drill does not start	Battery not charged	Charge the battery and try again.
Bit slips in chuck	Chuck not tightened	Tighten the chuck securely.
Overheating	Continuous use	Allow drill to cool down before further use.
Low power	Battery low	Replace or recharge the battery.

Reset: If issues persist, consult the user manual or contact customer support.