Dewalt DXH50K Manual

The Dewalt DXH50K is a powerful 50,000 BTU portable heater designed for construction sites and other large spaces. It features a durable design, easy portability, and efficient heating capabilities. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: High-efficiency burner, adjustable heat settings, built-in safety features, and a rugged design for job site durability.

Feature	Description
High-efficiency burner	Provides rapid heating with minimal fuel consumption
Adjustable heat settings	Allows for customizable temperature control
Built-in safety features	Includes tip-over protection and overheat shut-off
Rugged design	Durable construction suitable for harsh environments
Portable design	Easy to move with built-in handles and wheels

Installation

Ensure the heater is placed on a stable, flat surface away from flammable materials.

1. Unpack the heater and inspect for any damage.
2. Connect to a suitable fuel supply as per the manufacturer's instructions.
3. Ensure proper ventilation in the area where the heater will be used.
4. Plug into a power source if applicable.

WARNING! Follow all safety guidelines to prevent fire hazards.

First-Time Setup

Before operating the heater, ensure all connections are secure and the area is safe.

1. Check fuel levels and ensure the heater is properly connected.
2. Turn on the power switch and set the desired temperature.
3. Allow the heater to warm up before adjusting settings.

CAUTION! Always monitor the heater during operation.

Specifications

• Heating Capacity: 50,000 BTU.
• Fuel Type: Propane or natural gas.
• Power Source: 120V AC for electric models.
• Weight: 50 lbs.
• Dimensions: 24 x 18 x 18 inches.
• Safety Features: Tip-over switch, overheat protection.
• Operating Temperature: Suitable for outdoor and indoor use.

Controls and Settings

Access controls via the front panel. Features include power switch, temperature dial, and safety reset button.

Remote: Some models may include a remote control for convenience.

Adjust settings for optimal performance based on the environment.

Connecting Fuel Supply

Ensure the heater is off before connecting to the fuel supply.

1. Check for leaks in the fuel line before use.
2. Connect the fuel line securely to the heater.
3. Open the fuel valve slowly and check for proper operation.

Tip: Always use the recommended fuel type for optimal performance.

Operating the Heater

Follow the operating instructions for efficient heating.

1. Turn on the heater using the power switch.
2. Adjust the temperature dial to the desired setting.
3. Monitor the heater during operation for safety.

WARNING! Do not leave the heater unattended while in use.

Safety Features

The heater is equipped with multiple safety features to prevent accidents.

• Tip-over switch that automatically shuts off the heater if it falls.
• Overheat protection to prevent overheating.
• Safety instructions must be followed at all times.

Care & Maintenance

Regular maintenance is essential for safe operation.

• Clean the heater regularly to prevent dust buildup.
• Inspect fuel lines and connections for leaks.
• Store the heater in a dry place when not in use.

CAUTION! Always unplug the heater before performing maintenance.

Regulatory Information

This heater complies with all applicable safety standards and regulations. For more information, visit the Dewalt website or contact customer support.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Heater does not start	No fuel supply	Check fuel levels and connections.
Uneven heating	Blocked vents	Clear any obstructions around the heater.
Excessive noise	Loose parts	Tighten any loose components.
Flame goes out	Wind or draft	Move the heater to a more sheltered location.

Reset: Follow the manufacturer's instructions for resetting the heater.

Service: For assistance, contact Dewalt customer support.