Dewalt Manual DW705

The Dewalt DW705 is a powerful 12-inch compound miter saw designed for precision and durability. It features a robust motor, adjustable miter and bevel settings, and a laser guide for accurate cuts. Ideal for both professional contractors and DIY enthusiasts, the DW705 is perfect for a variety of cutting tasks including framing, molding, and crosscuts. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 12-inch blade, adjustable miter angles, laser guide, dust collection port, and ergonomic handle.

Feature	Description
12-inch blade	Provides a wide cutting capacity for various materials.
Laser guide	Ensures precise cuts by projecting a line on the workpiece.
Adjustable miter angles	Allows for accurate angled cuts up to 50 degrees.
Bevel adjustment	Enables bevel cuts up to 45 degrees left and right.
Dust collection port	Connects to a vacuum for cleaner workspace.
Ergonomic handle	Designed for comfort and reduced fatigue during use.

Installation

Unpack and inspect the saw. Place it on a stable work surface.

1. Attach the saw to a workbench or stand for stability.
2. Connect the dust collection port to a vacuum if desired.
3. Ensure the power cord is properly routed and not a tripping hazard.

WARNING! Ensure the saw is unplugged during setup to avoid accidental start.

First-Time Setup

Power on the saw and familiarize yourself with its features.

1. Adjust the miter and bevel settings as needed for your project.
2. Test the laser guide alignment before making cuts.
3. Practice making cuts on scrap material to ensure accuracy.

CAUTION! Always wear safety goggles and hearing protection when operating the saw.

Specifications

• Blade Size: 12 inches.
• Motor Power: 15 amps.
• Bevel Capacity: 45 degrees left and right.
• Miter Capacity: 50 degrees to the right and 45 degrees to the left.
• Weight: 45 lbs.
• Dust Collection: Yes, with compatible vacuum.
• Laser Guide: Yes, included.

Controls and Settings

Access miter and bevel adjustments via the knobs located on the saw.

Power Switch: Located on the front for easy access.

Adjustments: Miter and bevel angles can be locked in place for consistent cuts.

Connecting Devices

Ensure the saw is unplugged before connecting any accessories.

1. Connect the dust collection system if using.
2. Ensure all adjustments are secure before powering on.

Tip: Always check the power source compatibility before plugging in.

Operating the Saw

Follow these steps for safe operation:

1. Ensure the workpiece is secured before cutting.
2. Power on the saw and allow it to reach full speed.
3. Make the cut using a steady motion, following the laser guide.
4. Turn off the saw and wait for the blade to stop before removing the workpiece.

WARNING! Never reach over the blade while it is in motion.

Maintenance

Regular maintenance is essential for optimal performance.

1. Clean the saw after each use to remove dust and debris.
2. Check blade for sharpness and replace if necessary.
3. Inspect power cord for damage and replace if frayed.

CAUTION! Always unplug the saw before performing maintenance.

Safety Information

Read all safety instructions before operating the saw.

• Always wear appropriate personal protective equipment.
• Keep hands away from the blade at all times.
• Do not operate the saw in wet or damp conditions.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Saw won't start	Power source issue	Check power cord and outlet.
Blade not cutting	Dull blade	Replace with a sharp blade.
Excessive vibration	Loose parts	Tighten all screws and bolts.
Laser guide misaligned	Adjustment needed	Realign the laser guide according to instructions.

Reset: If applicable, refer to the manual for reset procedures.

Service: For support, contact Dewalt customer service.