Dewalt Manual DW733

The Dewalt DW733 is a powerful portable thickness planer designed for professional woodworkers and DIY enthusiasts. It features a 15-amp motor that provides a smooth and consistent cut, making it ideal for planing hardwoods and softwoods. The DW733 is equipped with a 3-knife cutter head that delivers a superior finish and reduces snipe. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Planer 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 15-amp motor, 3-knife cutter head, adjustable depth control, and a built-in dust port.

Feature	Description
15-amp motor	Provides powerful performance for smooth planing.
3-knife cutter head	Delivers a superior finish and reduces snipe.
Adjustable depth control	Allows for precise thickness adjustments.
Built-in dust port	Connects to a vacuum for efficient dust collection.
Portable design	Easy to transport and set up on job sites.

Installation

Unpack and inspect the contents. Place the planer on a stable surface.

Ensure the planer is unplugged before installation.
Attach the dust port to a vacuum for optimal dust collection.
Adjust the feet for stability on uneven surfaces.
Plug into a suitable power outlet.

WARNING! Ensure all connections are secure and the area is clear of obstructions.

First-Time Setup

Power on the planer and familiarize yourself with its controls.

Set the desired thickness using the depth adjustment knob.
Ensure the cutter head is properly installed and secured.
Test the planer on a scrap piece of wood to adjust settings.

CAUTION! Always wear safety goggles and ear protection when operating the planer.

Specifications

Motor: 15-amp.
Cutter Head: 3-knife.
Planing Width: 12 inches.
Planing Depth: Up to 1/8 inch per pass.
Weight: 80 lbs.
Dust Port Diameter: 2-1/2 inches.
Power Source: 120V AC.

Controls and Settings

Access the depth adjustment knob and power switch located on the front panel.

Features: Depth adjustment, power switch, and dust port connection.

Connecting Devices

Connect the dust port to a vacuum for efficient dust collection.

Ensure the planer is turned off before connecting.
Match the dust port to the vacuum hose.

Tip: Keep the work area clean and free of debris.

Operating the Planer

Follow these steps to operate the planer effectively.

Power on the planer and set the desired thickness.
Feed the wood slowly into the planer.
Monitor the output for consistent thickness.
Turn off the planer after use and unplug it.

WARNING! Do not force the wood through the planer; let the machine do the work.

Maintenance

Regular maintenance is essential for optimal performance.

Clean the dust port and cutter head after each use.
Check and replace knives as needed.
Store the planer in a dry place when not in use.

CAUTION! Always unplug the planer before performing maintenance.

Safety Information

Read all safety instructions before operating the planer.

Wear safety goggles and ear protection.
Keep hands away from the cutter head.
Do not operate in wet conditions.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Planer not starting	Power connection	Check power cord and outlet.
Uneven cuts	Knife alignment	Check and adjust knife alignment.
Excessive noise	Worn bearings	Inspect and replace bearings if necessary.
Dust not collecting	Blocked dust port	Clear any blockages in the dust port.

Service: For support, contact Dewalt customer service.